ifconfig命令 – 显示或设置网络设备

  网络通讯

ifconfig命令的英文全称是“network interfaces configuring”,即用于配置和显示Linux内核中网络接口的网络参数。用ifconfig命令配置的网卡信息,在网卡重启后机器重启后,配置就不存在。要想将上述的配置信息永远的存的电脑里,那就要修改网卡的配置文件了。

语法格式:ifconfig [参数]

常用参数:

add<地址> 设置网络设备IPv6的IP地址
del<地址> 删除网络设备IPv6的IP地址
down关闭指定的网络设备
up启动指定的网络设备
IP地址指定网络设备的IP地址

参考实例

显示网络设备信息:

[root@linuxvip ~]# ifconfig
eth0 Link encap:Ethernet HWaddr 00:50:56:0A:0B:0C
inet addr:192.168.0.3 Bcast:192.168.0.255 Mask:255.255.255.0
inet6 addr: fe80::250:56ff:fe0a:b0c/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:172220 errors:0 dropped:0 overruns:0 frame:0
TX packets:132379 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:87101880 (83.0 MiB) TX bytes:41576123 (39.6 MiB)
Interrupt:185 Base address:0x2024
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:2022 errors:0 dropped:0 overruns:0 frame:0
TX packets:2022 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:2459063 (2.3 MiB)
TX bytes:2459063 (2.3 MiB)

启动关闭指定网卡:

[root@linuxvip ~]# ifconfig eth0 down
[root@linuxvip ~]# ifconfig eth0 up

为网卡配置和删除IPv6地址:

[root@linuxvip ~]# ifconfig eth0 add 33ffe:3240:800:1005::2/64
[root@linuxvip ~]# ifconfig eth0 del 33ffe:3240:800:1005::2/64

用ifconfig修改MAC地址:

[root@linuxvip ~]# ifconfig eth0 down
[root@linuxvip ~]# ifconfig eth0 hw ether 00:AA:BB:CC:DD:EE
[root@linuxvip ~]# ifconfig eth0 up
[root@linuxvip ~]# ifconfig eth1 hw ether 00:1D:1C:1D:1E
[root@linuxvip ~]# ifconfig eth1 up

配置IP地址:

[root@linuxvip ~]# ifconfig eth0 192.168.1.56 
[root@linuxvip ~]# ifconfig eth0 192.168.1.56 netmask 255.255.255.0
[root@linuxvip ~]# ifconfig eth0 192.168.1.56 netmask 255.255.255.0 broadcast 192.168.1.255